關于TACONOVA液壓平衡最常見的十個問題（中英文）
TacoSetter（直列式、旁通式和 Hyline 式）
用于天氣補償或室溫控制的加熱和冷卻系統
TacoSetter (Inline, Bypass and Hyline)
Use in weather-compensated or room temperature controlled heating and cooling systems
1. 應該在哪里讀取流量——浮子的頂部還是底部？
Where should I read off the flow rate – at the top or bottom edge of the float?
應該在浮子的底部讀取流量。
You should read off the flow rate at the bottom edge of the float.
2. TacoSetter 可以雙向流動嗎？
Can a TacoSetter take flow in either direction?
不可以，只能沿箭頭方向流動。
No, the flow must only be in the direction of the arrow.
3. 它可以安裝在任何位置嗎？
Can it be installed in any position?
是的，基本上任何安裝位置都可以，包括側向或甚至倒置。但只有一個例外：在 TacoSetter Bypass 上，旁路手柄不能位于頂部，否則檢查窗中可能會積聚空氣。
Yes, essentially any installation position is possible, including sideways or even upside down. There is just one exception, though: on the TacoSetter Bypass, the bypass handle must not be at the top, otherwise air can build up in the inspection window.
4. TacoSetters 上的字母（A、B、C...）代表什么？
What do the letters (A, B, C...) on the TacoSetters mean?
最高字母代表輪子的最大開啟設置，允許通過閥門的最大流量。每增加一個字母，流量就會逐漸降低。
The highest letter represents the most open setting of the wheel, which allows the maximum flow rate through the valve. Each additional letter then reduces the flow rate progressively.
5. TacoSetters 是否配有關閉裝置？
Are TacoSetters fitted with shut-off devices?
是的，所有 TacoSetters 都配有關閉裝置。但是，仍有可能出現殘余泄漏。
Yes, all TacoSetters are fitted with shut-off devices. Residual leakage is still possible, however.
6. 關閉或斷開旁路對主流量有影響嗎？
Does closing or disconnecting the bypass have any effect on the main flow rate?
沒有影響。
No, it does not affect it.
7. TacoSetters 可在多少比例的乙二醇下運行？
At what percentage of glycol can TacoSetters be operated?
它們可在高達 50% 的乙二醇下運行。
They can be operated at up to 50 % glycol.
8. 為什么乙二醇校正曲線僅提供至 DN25？
Why are glycol correction curves available only up to DN25?
對于較大的尺寸，不需要校正系數，因為任何變化都會在測量公差范圍內。
For larger dimensions, no correction factor is required, since any variations will fall within measuring tolerances.
9. 旁路上的紅色滑塊有什么用處？
What is the red slider on the Bypass for?
紅色滑塊就是所謂的記憶滑塊?？梢允謩诱{(diào)整，以便突出顯示設定點并使其易于查看。
The red slider is what is known as a memory slider. It can be adjusted by hand so that the setpoint is highlighted and easy to see.
10. TacoSetter 是否需要直進風管？如果需要，進風管的長度是多少？
Does a TacoSetter require a straight inlet run? If so, how long does it have to be?
是的，它需要直進風管，長度等于 TacoSetter 本身的長度。
Yes, it does need a straight inlet run, equal to the length of the TacoSetter itself.
聲明：
- 文章轉載自TACONOVA，由愛澤工業翻譯，如有侵權，請聯系刪除！
- 如有偏頗，歡迎指正！
